![]() Router# debug_bsm_command:DEBUG_BSM_SESSION_ALLĢ3:49:14:SESSION:XPORT:sig rcvd. Router# debug backhaul-session-manager session all The following is output for the debug backhaul-session-manager session all command: This command was integrated into Cisco IOS Release 12.2(33)SRA. This command was implemented on Cisco AS5350, Cisco AS5400, and Cisco AS5850 platforms. This command is not supported on the access servers in this release. This command was implemented on Cisco IAD2420 series integrated access devices (IADs). This command was implemented on the Cisco AS5850 platform. This command was implemented on the Cisco AS5350 and Cisco AS5400. This command was implemented on the Cisco 2600 series, Cisco 3600 series, and Cisco MC3810. Support for this command was introduced on the Cisco 7200 series routers. Provides traces for all packets (protocol data units (PDUs)), application PDUs, and also session-manager messages.ĭebugging for backhaul-session-manager session is not enabled. SESS_SET_SWITCH_OVER: An ACTIVE notification is received on session-group in-service, which had received STANDBY notification. ![]() SESS_SET_FULL_IS: A session-group in-service that has ACTIVE notification and at least one session-group in-service that has STANDBY notification. SESS_SET_STNDBY_IS: A STANDBY notification is received, but there is no in-service active session-group available. STANDBY notification has not been received on any available session-group(s). SESS_SET_ACTIVE_IS: An ACTIVE notification has been received over one in-service session-group. No ACTIVE notification has been received from Virtual Switch Controller (VSC). SESS_SET_OOS: A session(s) has been added to session-group(s). ![]() SESS_SET_IDLE: A session-set has been created. Shows information about state transitions. No debug backhaul-session-manager session ![]() To disable debugging output, use the noform of this command. To debug all the available sessions or a specified session, use the debug backhaul-session-manager session command in privileged EXEC mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |